Drilling is a destructive entry method, so it should normally be used after exhausting other unlocking techniques. This means that using it on the lock will damage the mechanism and will require its replacement. Can you drill out a door lock?
Find a different way home
The door was indeed closed, as were the windows surrounding it. During the inspection no door was found to be unlocked. There were no other doors that could be successfully selected or hit. Tools under the door and the like proved to be useless. There is simply no other way to get that person back home than to use a destructive entrance. Time has been devoted to the full resolution of this situation, and this decision is not taken out of haste or pressure. Do not drill the lock at any time if there is a way to avoid damaging the customer’s property.
Lock preparation
Before you drill a lock, you need to make sure you can drill it. There are several locks that are made of security devices (criminals are there) and will prevent them from being drilled. In this case, other methods may be necessary.
If the lock is in your home, there is a chance that you will be able to drill it. If you are unsure, consult your local hardware store, locksmith or manufacturer.
Remember to disable alarms if the door is connected to the alarm system.
Understand the lock well to drill it correctly.
Some locks will not open as easily as others, even when drilling. It makes no sense to drill a lock that has anti-drilling pins. These pins are made of hardened steel, making them harder than a drill. Particular attention should be paid to something like a euro cylinder. If the last pin is passed and the drill bit penetrates the rotating cam (almost always made of plastic), then turning the plug will never unlock the door. Without understanding the locking mechanism, drilling the lock is counterproductive. Pressure from the customer should not be an important excuse for attempting to destructively enter an unknown castle. A lock that is drilled unsuccessfully is a waste of materials and time. Don’t be afraid to drill a sluice, but know that when you do it, it won’t help full. On the perimeter of the house should be a lock that can be drilled.
Drilling process
- Glue the door template to the door so that it is square or aligned with the door edges. The door lock holes are approximately 2 3/8 inches to 2 3/4 inches from the edge of the door and are aligned with the center line of the door handle.
- Tap the nail set with a hammer over the center of the template holes and into the door surfaces and the side edge of the door to mark them.
- Wear safety glasses. Drill characters using a 1/8-inch, 2-inch deep pilot hole.
- Drill a lock hole in the door surfaces with a hole saw.
- Drill the snap hole with the blade tip by placing a point on the blade tip on the mark and drilling a 1-inch deep hole or as per the lock lock instructions if it has a different length.
- Position the bolt in the hole to check the fit. If necessary, carve the sides of the hole with a razor blade to match the latch. The lock is now ready to be installed in the door.
